The shotgun microphone windshield is constructed of a noise-free mesh base, with a coarse foam inside and our specially designed rubber mount at the bottom.
The combination of the foam and the mesh provides the perfect conditions for recording indoors. And if you suddenly have to act fast and go outside, simply slip-on the short-haired fur and experience the optimal transparency within seconds.
When your recordings are wrapped, you can always keep track of your Spacer Bubble by collecting the base and the fur slip-on in the included practical mesh storage bag. In that way you’ll always have your Spacer Bubble right where you need it.
9 good reasons for wanting the new Spacer Bubble:
- Specially designed rubber base for super easy and secure mounting,
- Base windshield made from highly efficient mesh
- Slip-on fur made from Bubblebee Industries’ best imitation fur (high amount of hair pieces per cm2) which allows for optimal frequency transparency
- Switch locations fast and always get the best transparency while blocking the wind noise
- Practical mesh bag included for easy storage and fast mounting
- Quick drying of the fur if it gets wet. You can just place it in the mesh bag
- Comes in seven different sizes – sure to find a size that perfectly fits your favorite shotgun mic
- Designed in Denmark by sound lovers, for sound lovers
- Save valuable time while getting best quality.
There are five different lengths and two different mount sizes:
Size XS: Length: 55 mm (2.2”)
E.g. use with following microphones: Audio-Technica AT 4053, Audix SCX1C, DPA 4006 & 4011, Neumann KM series, Røde NT55, Schoeps CMC seriES & Sennheiser ME 64 & 62 K6
Size S: Length: 105 mm (4.1”)
E.g. use with following microphones: Sony Camera Mic, JVC Camera Mic
Size M: Length: 130 mm (5.1”)
E.g. use with following microphones: Audio-Technica AT 877 & AT 4073, Schoeps CMIT 5U, DPA 4017, Sennheiser MKH 8060 & Sanken CS 1
Size L: Length: 155 mm (6.1”)
E.g. use with following microphones: Audio-Technica AT 835ST & AT 897, Neumann KMR 81, Røde NTG-1 & NTG-2, Schoeps Super CMIT5 & Sanken CS 2
Size XL: Length: 180 mm (7.0”)
E.g. use with following microphones: Røde NTG-3, Sanken CS-3 & CSR-2 & Sennheiser ME66 & MKH416
Size XS Big Mount: Length: 55mm (2.1″)
Use with the following microphones: Sennheiser MKH30, MKH40, MKH50
Size XL Big Mount: Length: 180mm (7.0″)
Use with the following microphone: Sennheiser MKH60